The Jalopy Journal
12 v system I tried to start my Jeep with the battery and it won't turn over so it seems those who said bad battery are right. Guess I'll be...
Problem is the battery is only a month old and has been starting Ok. So even if the meter or charger is mis=reading the amount of charge it should...
Not the chargers because I have 2 and both read the same and show acurately other batteries I put it on. Same for the volt meter it reads ok on...
This is one for the hokey ass board 'cause my battery is truly acting "hokey" Issue is: My Model A has a new battery, fully charged and verified...
OK I may have misnamed the contact on top of the starter that when depressed it makes contact with the starter to start. What ever that is called...
When I depress the starter floor button the starter turns over once then I lose all electrical. The stater and solenoid were replaced 4 years ago....
I ordered the pin removal tool so will be trying that The heat and wax sounds like it could speed up the process so I'll be trying that as well....
would heating the hinge screws rather than the hinge pins also work DYT? would save damage to the outside of the paint job.
Ready to give up so any ideas will be appreciated. I need to bondo the very bottom of the doors on my '31 Model A pick up. Problem is I can't get...
Thanks for all those great "tips" But I'm leery about jumping a 6 v with a 12v cause the gages and ignition coil could be damaged and the battery...
I have a car still with a 6v system. And I'd like to get a portable jump starter in case I break down and need a jump start (again). Last time I...
Separate names with a comma.
The Jalopy Journal