The Jalopy Journal
You should Red Oxide primer it. Then sand through to black. Start a trend! [ATTACH]
16 KH. 450/700 [ATTACH]
Nick, if you’re going to replace the regulator at some point, I would look for an NOS one on eBay or what-have-you. 1956+. Atlas, Echlin and such....
Just put this up tonight. Oil and maybe a wrench to some fasteners. Leaving Friday at some point. [ATTACH]
[ATTACH] [ATTACH] [ATTACH]
A properly setup distributor with “quality” points and condenser along with coil and resistor (if needed) is the only advice I have.
@CSPIDY nailed it.
Thank you! 700 rear. 450/475 front.
Can you zero a dial indicator from your decks to top of stroke at piston? Your favorite machinist with a fly cutter should be able to help you...
It’s a bobber.
[ATTACH]
I’ve experienced a “ticking” noise coming from up front and it was the fiber cam gear on an 8ba. Replaced it with an aluminum one and all was good.
Put your point set back in. That’s all I got.
I’ve said this already; eliminating all that nonsense would be the best move. Just sayin.
Maybe take a look at the cap and rotor as well? My recommendation is to gas that Pertronix and set up a distributor with a quality point set and...
Separate names with a comma.
The Jalopy Journal