The Jalopy Journal
That would work. I wouldn't have to disturb the tank in any way. Wouldn't even have to drain it.
I can't use the filler neck. It's too close to the tank. So, I guess you didn't run a tube to the bottom of the tank to avoid static, and you...
Thanks Anthony! I believe that will work. I hadn't thought about that. Is it really a thing? A gas tank would be a bad place for a static...
I built the gas tank for my '26 Ford T coupe from 16-gauge steel. It is 12" tall x 7" wide x 40" long. It sits across the car in the trunk on...
I used those small OD valve seals on my .531" guides. They are a bitch to get off. I had to get destructive to remove them. My dual springs...
I'm ordering valve stem seals for my SBC. I see seals made from Viton and some from PTFE. Is there an application where you would use one but...
This probably won't last long . Check out Coleman Machine in Menominee, MI. They used to carry a screw on wide 5 snout for Impala spindles.
I had the '26 out this morning. Got to the first corner and my turn signals aren't working. Great! No turn signal. no hazards. Fuse is good....
Put engine at TDC and mark the balancer at 0 on the timing tab.
Well, I decided that I wanted a stock covered visor, but every place I tried had the frame on backorder. Same with the cover. I did find an...
Purple Power is good stuff. I use it, too. Just don't let it set it on polished aluminum!
Yes, I know that the cam is probably the single most important piece of the TC puzzle. I had this cam custom ground on a 112 lobe center. It is...
Separate names with a comma.
The Jalopy Journal