The Jalopy Journal
Morris or Morris-Commerical
I am trying to find con rods 7.25 inches long to fit a 2.25 crankshaft and an inch wide at the big end the wrist pin size is not important. Thanks...
Detail of Mumford Link
Maybe consider a Mumford Link it only attaches to the ends of the axle tube and gives a nice low roll center
Jaguar MK11 cantilever rear suspension the front half of the springs mount inside the chassis rails a bit smoother than 1/4 ellipticals due to...
Not 3350hp but 3800hp
You might take a look mercedes W196 & 300SLR from the early fifties, they were one of the last high performance straight eight engines and they...
Maybe a blown headgasket between 1 and 2
Yes to all of the above plus seven pounds of boost
Is there much advantage in running the first dual point crab distributor 1940-42 over the later 1942-47 single point crab distributor, i e is the...
Btt
Are there any 5 lug on 6 inch PCD 16 inch wheels, I was told that some mid 30s GM had them but I cant find any reference to them
Separate names with a comma.
The Jalopy Journal
Post
