The Jalopy Journal
Good times. Mister T's was always our Friday night, Whittier Blvd. destination.
Oil drain plugs from a 2002 Dodge 360 have a nice, built in rubber seal. Make sure the female threads are the same (1/2"x20) when retrofitting.
As much as I love a SBC, I went with the Chrysler 392 because it can motovate a FED to 4 second runs down the 1320.
A short piece of rubber hose can serve as a depth gauge/bumper when slid over a drill bit.
64 IH 3/4 ton awd pto 345 4 speed [ATTACH]
Heads up [ATTACH]
When installing new races into a rear axle housing, I put the races in the freezer first. when they are truly cold, grease and tap them in place...
When the shop sink, tub or shower drains slow, a shop vac will usually suck it clean in about 10 seconds. Have needle nose pliers handy. Take the...
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
found on boogle images[ATTACH]
RTFM (read the friggin manual)
Removing a pitman arm. Install your cheapy pitman arm puller, snug it down with a wrench, add a little heat from a propane torch on the pitman arm...
still sitting in my front yard.......[ATTACH]
I shot this in Bodie, CA. Circa 2001[ATTACH]
[ATTACH]
Separate names with a comma.
The Jalopy Journal