The Jalopy Journal
250 / 292 throttle bracket,...
If its HEI, the small green and yellow wires do go bad from the pickup coil to the module. The vacuum advance is always pulling on them, that...
Was the engine tight before you started it? Thick old school rings, or thin modern rings? Rough cylinder hone, or extra fine? Most new...
I fixed a GTO with a rough over rich idle with one of the MisterGasket round regulators. I never checked the pressure, just turned it down till...
Thanks for information, I will change my schedule to one year.
I have a question, does oil go bad from setting? If the vehicle is parked in a climate controlled garage or low humidity climate, and is...
I do the same on the HEI's only use alittle longer piece so it gets screwed down with the original mounting screw. I also slot the hole so I can...
Try this, https://www.blocklayer.com/pulley-belteng
As a safety note, PULL the coil wire off if you are going to crank the engine over with plugs out. A friend was having the same issues of...
A 1000 rpm speedometer cable will read 60 miles per hour, that is the standard calibration number for nearly all speedometers. Its the rear axle...
Accelerating around a corner lowers the temp??? Nothing about going around a corner will change the cooling system, it's the higher rpm. The...
The wrap is pretty normal on O2s. The 10 you are seeing is likely right, if the gauge moves higher at idle, then you know its reading. Mine was...
I run the same tire sizes with no issues. I changed the leaf springs, front went down, steering got loose, I changed the caster ( gave it one...
http://www.wallaceracing.com/interchange.htm
Rubber bushings should be compressed to washer size + a little more, they should bulge out slightly past the washers with no gaps between....
Separate names with a comma.