The Jalopy Journal
Don't raise the bridge, lower the river....I mustve done something wrong.....I used Jamco frame mounts that were supposed to be for a SBF and made...
Started building this before I got my 50 ford....now it falls under the too many projects area and I hate to see it sit....I am using the drive...
Normally your points need to run at 6-8 volts....keeps them lasting longer.....the ballast resistor does that....its wired in such a manner that...
Here is the steel 33 I built for my dad just before he died.....It started out as a coupe, but he wanted a roadster....those are 32 ford...
For anybody interested, Its listed for sale on the bay.........
Im going through the same thing with my 46, and since ive used the paul horton welder series crossmembers before...
I agree....and I can see a faint outline of where a light mounted on top, turn signal or parking light?....the hole was probably for a hollow...
Hey Butch....went to the NADA again and heres what I found...It shows to be a 1950 frame, yes, made in California....heres exactly what the book...
Ive got a 1950 N.A.D.A Used car guide that I usually find all kinds of good information in......I looked up your merc and it states firstly that...
take the retaining bolt off of the sender, pull the whole thing out......carry it down to your transmission shop, and swap it for one with a...
No, it wont make it spin backwards, in fact, it will give it quite a kick....so use it for short bursts....The issue you WILL have is if you want...
Im amazed at how many different opinions there are on something so relatively minor.....I put them on my 41 merc because Ive grown tired of seeing...
I built this 33 for my dad, it was his last car before he died...It had originally been a coupe. I used 32 ford stanchions, and fabricated the...
I did quick look/see on EBay ......found 3 of them, from $10 on an old used on to almost $100 for a brand new fulton.....Ive got that kind of...
Separate names with a comma.
The Jalopy Journal