The Jalopy Journal
Thanks for the photos. Always look forward to your coverage of these shows.
Kind of looks to me with the U-bolt set up and what looks to be a grease fitting going into what appears to be some kind of a collar that rear...
My old 98 Dodge doing its thing. Last of the 12 valves, cam plate and governor spring kit, extrude honed injectors, 4" exhaust and a beefed trans....
This sits on farmland near me, where sure bet it floods almost every year. On a dead-end road with not much traffic. I've never seen the car other...
Nice save Marty! And the tank, Wow!
A high winding injected small block in a fly weight model A. I'm not falling for that "not going to have a chance" stuff! I was born at night, but...
Good morning. Have not looked at this thread for awhile. Nice job!
Sounds like fun! Always a blast when it's a close race running side by side, hope that's the way it is when we go at it. Happy New Year to you as...
Truck looks great Marty!
Brad Anderson AA/Gas. [ATTACH]
The finishing the flare with the inverted nut into the fitting is a good tip, I like to sneak up on it, tighten a bit, back off and go again, go...
Have a Merry Christmas everyone! [ATTACH] [ATTACH] [ATTACH]
I mentioned this on a different thread a long time back. The photos of the orange truck with the laid-back windshield style chop were taken at...
Strip Tripper. Paint on this thing is still amazing considering it's been on the truck for quite a while. [ATTACH] [ATTACH] [ATTACH]
Cory Taulbert build. Beautiful. [ATTACH]
Separate names with a comma.
The Jalopy Journal