The Jalopy Journal
Sounds good, we'll try that sometime this week
I have a temp gun and we will probably just watch temps without water since the water pumps are off, don't plan on running it for more than 30...
Hey guys, been a little while. We finally got around to working again, we put the intake manifold and carburetor on and tested the starter using a...
We got bolts, but no bracket
Nothing changed, it performed the same as the old ones. We’re still forced to use jumper cables, but we’re going to try a 12v jump pack. It sucks...
Hey guys, just another update. We had the starter rebuilt, it was $125 and it came back in a day, it looks good, even painted, and has a 1 year...
Yea the engine is sitting on a tire in my friends garage right now, we wanna make sure its not a boat anchor before we go through the trouble of...
so I need copper cables, 4 awg or 1 awg are you recommending?
Do I need 6v battery cables? We could maybe borrow some from one of our Model A’s, but would a 12v cable work? I could borrow some from my 77 f150
The threaded rod was a last resort at we couldn’t find bolts for the starter. I had heard that bolts for the generator and the same as the...
maybe it’s possible, but could the use of jumper cables instead of starter wires really be that big of an issue that our starters have almost no...
Any movie recommendations?
Thank you for all this information. So far on this entire project, we have spend a total of $470 on 2 complete 59a flatheads, a dual carb fenton...
Our stucky flatty has a valve that poked through the lifter. One cylinder is completely covered in rust. There is no way we could've freed it up,...
We've checked clearences and confirmed that the rod is not contacting the ring gear or the flywheel. What exactly is that bracket for?
Separate names with a comma.
The Jalopy Journal