The Jalopy Journal
I have a Harrison KHE 300-usb radio for a 54 ford and scuff plates for a 2 door 54 ford. Both are new still original wrapper and believe radio is...
I put an aluminum shaft out of a crown vic police car, perfect fit.
Actually if you are dealing with carb and distributor and on a budget, Rebel wiring harness serve quite well. I actually spent more money adding...
I used the rebel 9+3 in my car and like everyone says it's easy to use. The wire used in the harness seem to be of good quality, but the fuses,...
Here is EFI Guy's info 303-200--0246 Garred Vance 6051 W. 78th PL. Arvada, CO 80003 Garred is a great guy and usually has an answer to most any...
That's the right link for EFI guy, talk to him, if you want answers that work. I never run mine thru the gears manually, but thinks it will work...
I'm running EFI a 4R70W and 373 pos in my 54, wouldn't have it any other way. I've had the ecu remaped for more horsepower harder shifts and to...
I set my reared 1 degree less the what was measured at the transmission output shaft. My transmission was pointing down 6 degrees so I set my...
Bob Drake sells a tank for the 55 with provision for an oem fuel sender and provisions for an in tank fuel pump. Only thing you have to buy their...
If your talking about an OEM computer and motor I did that very thing. it requires you remap the computer to get rid of the things you won't be...
Mine are mounted just in front of the battery. The whole point is to make the feed wire as short as possible is the way I looked at it.
Man here I have been patting myself on the back and my engine just up and quits. So I think I must be out of gas so I put 5 gallons in the car and...
I had the same problem, finally had to go to an earlier timing cover with the dipstick provision and then used aftermarket power steering and...
Separate names with a comma.
The Jalopy Journal