The Jalopy Journal
enough to handle 40a [assuming the ammeter an handle 35a] An 8 gauge wire typically has an amp rating of 40a.
The govt would legalize lynching if I tried that in New Zealand. Cutting the roof off a unibody platform ,then grafting the rear half a ladder...
Here is the "holy grail" of chassis swaps ,the "Chevota Priuck" ! :D:D:D [MEDIA]
700hp isn't needed. @6sally6 could "have his cake and eat it" with 5.14 gears and a T56 trans. A 350hp engine in a 2800lb car is good for 11.6...
What's the objective ??? A Burnout car or a Drag car? You can set the suspension up to do either, but not both at the same time. Also power and...
The longtail fin improved directional stability at high speeds [the drivers could take their hands off the wheel at 170mph +] The fin was offset...
Purge it with CO2 or Argoshield gas. If you can't use the Tank Sender for a return hosetail , You can sometimes use the filler neck an put the...
That's what I am guessing! [aka Low drag callipers] These brake conversion kits usually have these ,and the vendors stick their head in the sand...
Have you got your engine back from "machine shop jail" yet? It's been over a year since you started this thread. If you must bolt that tunnel...
Let me guess? GM style Callipers? you shouldn't need any check valve for a firewall mounted M/C
convert an old shipping container by removing the sides and retaining the corner posts The sides can be made from clear PVC hf welded , so they...
I had this P.O.S Camaro [it really was] This car was a Bitsa that put me off Camaros for a long time [ATTACH]
Leave it alone, the desired 45° angle is a myth. As the suspension compresses the spring will arc outward [wider] The easy way out is to leave...
Diy it https://www.amazon.com.au/dp/B0BFX54HRF?ref_=mr_referred_us_au_nz
That is a good system with pure simplicity. I've also seen that on the front with a "Hairpin bone" on one side and a link on the other. Speedway...
Separate names with a comma.
The Jalopy Journal