The Jalopy Journal
Never ran into the problem of to low a fuel pressure. The seat height all depends on where the tang for the float is that will adjust the total...
Just measure at the lifter from .050 get max lift on the lobe multiply by the rocker ratio to get max lift.
Or in my garage:)
I had one explode. just got done setting the timing rpm was at 3600. Put the hood on, went to the starting line, launched the car shifted the...
Welcome from another PA er.
thank you
This thread is great. All the races I attended pics were the last thing on my mind. I saw a good many of these cars run. Please keep the pics...
If that is your scrap book and how you kept it you anr most defiantly "THE MAN":).
I've had my OL JIG -Joint for over 15 years. Made 100's of cuts never had a problem. Like people are saying run slow (usually a drill press isn't...
When we ran dirt track we used to put in or take out toe on the rear axle housing by heating it and cooling it. Once you do it a few times you...
Pittsburgh Pa. West Mifflin
Small cubes 4-5 speed RPM to the moon. Getting goose bumps.:D:D:D:D:D:D The predecessor to pro/stock. O yea.
If it was me I would lowwer the front ladderbar mount so the bar is at least level, but3-4* down would be better. Put a good set of adjustable...
The main jets effect alot of things including idle and transistion. The thing with drilling them is you'll change the opening and exiting chamfer...
Before I went drilling the jets(witch is a bad idea) I would mess whith the shooters and the secondery opening. If I'm not mistaken you'll have...
Separate names with a comma.
The Jalopy Journal