The Jalopy Journal
Go .003" per inch of bore, & not greater than .004" so a 3.125" bore would be .0094" total radial clearance (.0047" per side) under no...
How much oil? Is it a steady drip or you are finding residue?
Actually, you can't willy nilly just put anti-seize on stainless steel. It must be nickel based, otherwise you are creating a dissimilar metal...
I remember those days well, I only interacted if I had a solid technical input. Which for the most part is the same case.
I'm still around #247
Nice job on the baby's room. The changing table/tool box is very practical actually. All the best to your family with the new baby on the way....
As far as I know those clips are not reproduced. when you pull the window channels the clip typically stay with the old channel.
Those aren't Mercury specific. They come in 8' length, do you have the clips?
Aren't they easy to change in a flathead?
I did this about 20 years ago. The front sump pan from the 60s and 70s is a must. There is a small relief that goes into the left header for the...
Damn, I think that was his wife.
We got the same letter, I think it's part of the bankruptcy settlement.
1/8" npt is 27 threads per inch and female ID .380". It is often used for gauge line
Can you get a thread pitch gauge in it?
I would think 1/4" NPT. I see you are from New Zealand, it's not identical but very similar to 1/4" BSP
Separate names with a comma.
The Jalopy Journal