The Jalopy Journal
What a great shop!
Most of the kids these days are lucky to even have a job with min. wage pay, try filling up a fuel tank these days just to cruise on that pay! It...
Vintage trucks!!
Thanks guys, I hope im doing it right.
Here I made up a couple door hinge cage nuts for the upper hinges and just drilled a 1/8th inch hole in body to weld and hold in place, worked out...
Got the whole right side completed and welded in and started on the left side.
Here you can see where I had to lower and space in a spacer piece in the cab corner. I don't think it turned out to bad could of been allot worst!
Well as you guys will see I'm an armature at body working, My first mistake was I started at the rear cab corner and got it welded in too high up...
I got the drive line in and radiator & support in. Now on to the sheet metal.
Thanks guys! I will keep you posted. I bought the truck last year around september.
I heard that! Thanks!!
I got the stainless brake lines and fuel lines installed over the weekend and also installed the newly rebuilt steering gear, But will have to...
OK now were up to date with the build. I just got the engine back together painted and back in the frame. The engine was a mess with 4 pistons...
Thanks guys! Here I got the frame sandblasted and powder coated. Rear axle all gone thru with new bearings & seals. 3.90 ratio, when I took this...
Then I got the engine all torn apart. It was a mess.
Separate names with a comma.
The Jalopy Journal