The Jalopy Journal
That’s worked! I drilled the hole and pumped air in and the stainless popped off. Some of them didn’t pop off but the air separated it and made...
Phil, any update on how this turned out. I have what may be the same raw casting. I was looking at my pieces and it looks like I will have some...
Yea, I pulled the oil pan and looked at everything from underneath. Lots of sludge in the pan, about an inch deep. I think I’ll just clean it...
I don’t have any oil pressure in this Flathead 8BA. I pulled the engine and found that the gear on the end of the camshaft is spinning on the...
SOLD City: Clinton Township State: Michigan Price: $25 USD Original front model A front cross member. $25 plus shipping. Metro Detroit area.
I ended up doing this. The accelerator pump discharge jets were clogged, not squirting at all. I soaked the body in alcohol and threaded this...
That might work! I never heard of that before but I just watched a couple YouTube videos and it sounds like it works. Thanks for the suggestion....
I used long 1/2-20 studs with the spacer so that I didn’t have to drill the holes out on the wheel. Doing this I was able to use the correct lug...
Jaw22w, I think that would work for the wheel and tire but then I still need the hub/drum balanced. I’ll have to look at that bubble balancer,...
I have another question on this. Does anyone know where I can balance these rear wheels. I talked to the local tire shops like Belle Tire and...
Sorry for the late reply. I got them from Rally America out of California. http://rallyamerica.com/ I talked to a guy named Jimmy that works...
Separate names with a comma.
The Jalopy Journal