The Jalopy Journal
+1 That's bad ass!
Welcome, looks like a great start! You should start a build thread for your bad ass ride.
That's what I was thinking, "3000 mile and going bad even with an offshore bearing means you have other issues on that setup." The original...
Thanks Mr48, I think it's a weight/ cheap steel race issue myself because both sides did it on the top. The axle housing is not scared or out of...
I'm looking for a reason why these wheel bearings lasted less than 3k miles in under 3 months? The rear end has 130k on it and the Glock was...
I'll second that... re-solder it good as new.... save some cash.
Thanks Squirrel.....
How this go together??? clutch disk direction the engine is a 55 235 in a 48 chevy Fleetline so the clutch could be for the 235 or the 216?:confused:
Here's a write up in Ol'Skool Rodz mag. http://www.olskoolrodz.com/drivin-around/401/
Straight from the Flex a light web site... "WARNING: Must be used with a Fan Shroud!"
I'm rebuilding a 55 235 inliner and had to weld up a hair line crack in one of the blades, maybe I should be on the look out for a new one??? Road...
What is not debatable is your contribution to this site, eg: 454 post of "welcome" & "search" & "btt" how bout you put the keyboard down unless...
Separate names with a comma.
The Jalopy Journal