The Jalopy Journal
[ATTACH] [ATTACH]
Dead Mans Curve. Four day show in Mahwah NJ . This is one of the largest shows in the east with over 34 live bands . Thousands of hot rods , old...
What is a good tempersture thermostat to use? I am using a 180 . The sending unit is 195 on and 185 off. I installed the sensor for the...
I learned the main problem is the location of the mechanical fan , it's too low and too far from the radiator. No Mechanical fan would fix this...
The gauge is electric and it's new and a new matching sending unite. I did check the temp with a thermal temp gun and the the readings i am...
My initial timing is in that range 15-20 I tried some other fans but i could not find one that fits.
It took only about 5-10 minutes to get the temp up to about 230 and i turned the car off.
This blade looks good but it's 2.8" deep i only have about 2"
I checked my timing this weekend. All in @ about 2500 rpm it was 36 I bumped it up to about 38
I drove the car a few times this weekend. The car is running cooler when it is moving, it stays about 180 degrees. After a long ride i park in...
I think the Ricky Racer fan is not moving enough air.
Thank you and thanks for all the replies about this issue. It is real hot in Jeresy so i will get to test it all out this weekend. I might try...
This engine with a tunnel ram and two four barrels (390 cfm ) runs and idles like a dream. I don't think a vacuum advance will improve the engine
The heater heater hose fitting is capped. I think this is what you are talking about.[ATTACH]
Separate names with a comma.
The Jalopy Journal