Nailhead Jason's Recent Activity

Nailhead Jason liked Drylake's post in the thread Projects "I'm here to pick up the rubbish".

It is "copper Nickel", and is fine for brake lines. Thanks for your concern.
Jan 31, 2025 at 11:13 AM
Nailhead Jason liked deathrowdave's post in the thread Technical Broken Exhaust Flange Studs.

Lots of good ideas , don’t chuckle at the wax you will be amazed at the results . It works well . In the end I replace with stainless...
Jan 31, 2025 at 10:33 AM
Nailhead Jason liked alchemy's post in the thread Projects 32 make over started.

I would bet that the easiest rear suspension to install in this roadster, and it’s traditionalish too, would be a Pete & Jake ladder bar...
Jan 28, 2025 at 8:56 AM
Nailhead Jason replied to the thread Hot Rods Roadster Insulation And Sound Deadner.

Another Vote for KillMat. I Used the 80 mil on the floor, ceiling and double layer on the firewall in my 39 Tudor. I then used a Foil...
Jan 27, 2025 at 12:22 PM
Nailhead Jason liked HEATHEN's post in the thread Hot Rods Please tell me about Hurst motor mounts..

No it doesn't. All Hurst SBC mounts I've seen bolt to the 1955-57 mount holes on either side of the timing cover.
Jan 27, 2025 at 11:11 AM
Nailhead Jason liked Montana1's post in the thread Technical The making tube headers thread.

Not to be a s-a but, by the looks of your questions, they're not for the novice. Building a set of Stainless headers is NOT the place...
Jan 27, 2025 at 11:01 AM