The Jalopy Journal
got a reply from borgeson tech .said their shafts are not machined.just cut to length then the ends are splined.he said tolerance should be give...
sounds good
cmon Eric its not that hard 24.6 mm in an inch 1/8 =3mm approx.away you go.
my friend mike returned with my parts .must be tired lots of miles travelled. collected and gave the mirrors a trial on the spin home, by holding...
ted the first thing that i noticed about the pic was the mirror placement,at eye level and offering a good view of the road.when i see nice cars...
yeah i would think if they got a drop of oil/wd40 here and there before use could last a very long time,an investment
[IMG]also available in black
[IMG]i like these MIKALOR clamps.strong smooth design.pricy 4 times the cost of a similar plated item.high pressure clamp.as im only buying 4 i...
not out of the woods yet.spitting and farting during cold start up. sound like its leaned out too much..went shopping for a new top rad hose in...
have you brakes in the trailer?.yet
stevie arrived as promised.after a few running adjustment we set the float in vs it was set too high adjusted timing idle speed and mixtures to a...
it does not matter.the main thing is that it goes down the road.
sent summit an email asking about clearance between shaft and support bearing they advised contacting borguson with a link.i contacted them the...
well today put the steering linkage back together.measured up the joint i need.checked out everything for wear.what i found was the support...
https://normandybeachrace.com/en/ .id love to make it
Separate names with a comma.
The Jalopy Journal