The Jalopy Journal
OK X38 and gimpyshotrods, I get the message and thanks for the tip
Thanks quickchangeV8, Yeah other than the posting i saw, i haven't found one other single reference to a 4 X 2...
Running a cumulative cfm far beyond that which is required by even the most optimistic estimate of engine volumetric effeciency, at the most...
Thanks for the replies, cully33, i luv your coupe, quickchange v8, that list is bigger than i thought, i read...
Even if you use 81's, you are looking at 520cfm. 97's would be 600cfm, and 48's come in at 700cfm. Thanks for your replies,...
Hi Everyone, i am trying to find out how many manufactures made a 4 X 2 inline manifold for Flatheads. Thanks larry
I have spoken to Mike Davidson only just this morning and told him of the interest shown on this Forum, He told me to post his email address if...
Mike told me via email only last week that he is working on some 97's with EFI in the new billet carb bodies themselves and the butterflies become...
Thanks X38, At this stage i'm talking to Mike about the engine and how far i should go with it for a fairly much, daily driver,...
Clem, until a couple of days ago i have always been under the same impression as you, but i'm now not so sure. X38, i have been in email contact...
Thanks for the advice everyone, it's much appreciated, I had all intentions of using a 49-53 8BA engine but just in the last couple of days, both...
THAT !!!!! looks absolutely fabulous, I wouldn't even wash it, like a lot of blokes here have said, put 16/17 wire wheeels on it and just watch...
Mike51Merc, You're right, I think i must have read the ad wrong, I have a 34 Ford pickup with a 5.0 windsor with an auto, i am going to take the...
Separate names with a comma.
The Jalopy Journal