The Jalopy Journal
I have a 1948 Ford F3 and am either going to go with a 226 flat 6 or a 223 6 cylinder. I am wanting an overdrive transmission as it still has the...
I have a 226 ford flathead six cylinder, It is an H Series and I am putting on and Edmonds aluminum head. I am looking for the proper torque specs...
I have a Ford 226 flathead 6 cylinder and an Edmunds aluminum head. I was wondering what the torque should be for the head bolts? Sent from my...
Any other suggestions just to keep it the same width? Posted using the Full Custom H.A.M.B. App!
Currently the 4speed. Same as what is in my F-5. Posted using the Full Custom H.A.M.B. App!
Thanks, right now I am running a 4.86 and am getting maybe 55 mph tops with 17 inch wheels. Posted using the Full Custom H.A.M.B. App!
I was wondering what would be the best and easiest rear end swap to put into a 1948 Ford F-3 pickup. I have the original 226 6 cylinder which is a...
I was wondering if anyone here has done this before and if so how did they go about it? I am going to try and put one in my 1948 Ford F-3 pickup...
I am trying to put this on a 226 Ford Flathead 6 cylinder and put it into a 1948 F-3 pickup. Would the angle be correct? I currently don't have...
how much angle is too much? This has about 1/4 - 3/16 of an inch angle on the carb mounting base
Separate names with a comma.
The Jalopy Journal