The Jalopy Journal
My 50 F-1[ATTACH] Sent from my XT1710-02 using The H.A.M.B. mobile app
Sorry about all our confusion, we started out with a truck the rear axel was already changed. It has Chevy rally's on all four corners. When...
Trying to get to 5 by 4 1/2 Sent from my XT1710-02 using The H.A.M.B. mobile app
Thanks for the reply. This is the project truck[ATTACH] Sent from my XT1710-02 using The H.A.M.B. mobile app
I need some advice, we're putting together a 49 3100 Chevy and need to replace the rest end. I'm looking for something that will swap in with...
Cruising on the bay, 2019 Sandusky Ohio[ATTACH] Sent from my XT1710-02 using The H.A.M.B. mobile app
My 50 F-1, early fall colors[ATTACH] Sent from my XT1710-02 using The H.A.M.B. mobile app
I would try to find a '69-'70 Mustang master cylinder
Steve I'm not far from thereand can get you started on a relay. Send me a pm
I have had very good luck with mint extract from the health food store. I soak a few small rags and leave them in the car, trunk and under the...
I was doing front brakes and a tie rod on a OT car and I was pressed for time. Finished the brake pads then installed the tie rod, checked the toe...
[IMG] I have used the holesaw stlye cutters and have had success, use a little oil and don't turn them too fast. I found the rotary broach...
A friend of mine is a member and told me about it, I was telling him about the T roadster I was assembling parts for he told me I needed to check...
I am no expert at this and my answer may end up being off topic but here are my thoughts. On a supercharged engine all of the area down stream of...
Separate names with a comma.
The Jalopy Journal