The Jalopy Journal
There isnt any fish oil in rustoleum EXCEPT for the rusty metal primer, hasnt been for a long time. so no fish oil worries. its just enamel of...
the f body 8.5 rears were 28 spline axles, the newer 8.5s went to 30 or 31 spline I think so check that before ya buy one Doug
just shop around for a complete carrier with the gear set you want, used parts for an 8.5 rear are plentiful. check the for sale sections on...
Dan, are you looking for model a parts? , I might have a motor , and trans and some other stuff maybe
In was there too, sorry I missed you Danimal, Don said he saw you. the place was packed like sardines and the tables were not spread far enough...
there is no fin in a vortec truck head that I have ever seen. You may be thinking of an earlier design chevy played with. and to run a pair of...
those 88 vette / ZZ4 heads are really nothing special performance wise other than the aluminum looks good and is lighter. replacing the aluminum...
Vortec ports are about 1/4" taller iirc and tapered at the top. You would have to do a trial fit and maybe have to add some aluminum at the top...
only tv is going digital, radio will not change
you can trigger off the distributor no problem but a crank trigger is a more stable/ precise trigger. it also gets the ign trigger wire away from...
Any engine can be converted to efi. if you dont want to alter the intake to accept injectors then you can buy 4150 or 4500 pattern throttle...
the only strong 10 bolts are the 8.5" 10 bolts. they came in Camaros and Fireturds from 1971 thru 1981. the S10 and later model f-body rears are...
If you modify the distributor so it has less mech advance, then you can have the 32 degrees total timing that most vortec headed motors like and a...
I think the 10 bolt rears got a bad rap from the older pre 8.5" units. The 8.5" rear replaced the 12 bolts in some cars after 1970. I run...
I have built several 400 small blocks and really like them. I have very good luck with a standard melling m55 oil pump. a hv pump is one of those...
Separate names with a comma.