The Jalopy Journal
I always enjoy squirrel's input....
My 454 at 700 RPM has 16/17 inches of vacuum at the modulator valve with the line going directly into the intake manifold, is this enough to...
Where is the governor screen??
I'd have to recheck to be sure on vacuum but stock cam only
It currently shifts at about 60 to 62 MPR and if you are on a 55 MPH road it's a constant back and forth unless you're holding below 60 MPH then...
Yes and I believe the vacuum was about 12 to 14 as I recall checking it earlier. The line is directly to the manifold not the carb.
The turbo 400 in question is fresh rebuilt and installed behind a 454 in my custom COE truck. My complaint is the 2 to 3 gear shift points. This...
spring is new and no slack in components, not possible to rotate 360 deg, too tight. Don't know if spring end can be rebent, kanda doubt it....
spring has been replaced along with other components, you mentioned preload is there another way besides rotating spring 360 deg?
My 1939 GMC COE drivers window continuous to drop down a few inches even though I have replaced the spring. Is there any adjusting to increase...
October is near and Mississippi Gulf Coast is set for the biggest " Cruising The Coast " event ever. Hot rods by the thousands, all are...
Separate names with a comma.
The Jalopy Journal