The Jalopy Journal
The intake can be drill to fit but doesn't leave much sealing surface.
Edelbrock actually has a special plate to seal the carb to the manifold without using an adapter
just use a relay in the start wire, heat is causing to much resistance in the circut
i wonder who made him god, off topic or not
i know for a fact that a slip yoke will work did it to my sons 63 chev pu
It sounds like you have the hoses reversed
if you pull the pcv valve out and plug the hole in the valve cover you can put a vacuum gauge in the other valve cover and if you get a vacuum...
find a mid sixties chevy van, they had a 4sp on the column
you have to turn the piston as you compress it to get the piston to go back in, they screw in so you dont have to adust the parking brake all the time
a piece od a lead from a pencil will also work to reset the starter drive just slip in the groove and roll it back into place , damn im showing my...
shooting ducks too lean or vlave springs
there are some photos just just need to be seen over and over i have been through every page and couldnt tell you what has or has not been shown...
timing marks together is #6 but timing marks up #1 and no 400 that i know of had the tab behind the waterpump
diesel or aircraft id say they way they built it
this motor doesnt use the crank sensor like the 3.8 total different ignition system, my guess if someone pushed me into a corner would be an...
Separate names with a comma.
The Jalopy Journal