The Jalopy Journal
Couple of guys were loking at my rod with a flatty in it. "ive never seen a six cylinder with 8 spark plugs before. 3 exhaust pipes on each side...
Been looking around and it looks like graphtite is the way to go. Would you guys use copper sealer or any type of sealer on the gasket, or just...
Going to replacing the head gaskets on my motor and seal up some of the head studs so they quit leaking water. My question is which ones are...
Heres a few of my truck that I like....
Yes I did read what they said. Those are bonneville engines (race engines) mine is not. Mine is a mild street motor. I am using the mallory dual...
Ok, what rpm is best to have the advance all in?
How do you guys figure that you are getting 28 degrees since all that there is to go off of is a single mark on the crank pulley? It lopes pretty...
How far advanced should the timing be for my flatty with an isky cam? How much do they like??
I thought i heard, or read somewhere that if you are running more than one carb (im running 2 Holley 94's) you need an electric fuel pump. Is this...
What do you have the gaps set at on the points, cuznbrucie? My truck accelerates great and all is well, until I get up to about 3500 rpm and then...
bump:)
What is the pertronix part # for a mallory dual point distributor for a 8ba flathead? Is going the pertronix route better than running points on...
Separate names with a comma.
The Jalopy Journal