The Jalopy Journal
That's because you Ca. fellas roll down I-40, see the stuff, offer three times what we make in a year for it, and haul it out west by the truck...
That's what I was thinking. I'm shooting for the USFRa World of Speed, so I'm good. Now I just have to cut some more air out from under the front....
Thanks. I had read the rules, but a few other folks kept telling me that I still had to fit the specs for a class to run at all.
I'm looking to run a car in the 130 mph club, but I have a few questions for anyone who might be able to help. I have read everything that I can...
Any word yet on progress of these "integrated" wheel spacers? I'll be in need of a set and don't care for useing two pieces if it can be avoided....
I had seen that there might be one built in, but never did find conformation on that. Thanks for clearing it up. I'll pull the master cylinder...
Thanks. That is what I thought, but since the master was below the wheel cylinders from the factory, I was unsure. It is still below them and...
Ok I have searched and read all I can find on this subject, but I still have one question. My brake system (9"x 1.75" f/r drums) came with no...
Saying thanks may but be the greatest understatement in history, but thanks. You have cleared up a few points that I was unclear about. I will be...
my '52 hubs were inside. So wouldn't they still work the same? And wyh would the rear wheel cylinders be preferred?
Separate names with a comma.
The Jalopy Journal