The Jalopy Journal
Just my 2 cents but be careful with that old used regulator. Last year my old regulator failed and it took out my generator, boiled the water out...
Thanks for all your help Jim. We all appreciate it. Have a great day.
I currently have the same linkage on my carbs. Jon brings up a good point. On this linkage the secondary carb pivot balls that are installed on...
Hey, your car is beautiful either way, but I am biased to the steel wheels. Hope good health returns to you soon and I'm pulling for you...and...
Ha ha...Spending most of my life on old harleys I use loctite mainly on fasteners that I believe will see more vibration on my car. I very rarely...
@lostone have you tried twisting the pertronix module wires all the way to the coil, and using a dedicated ground back to the battery negative post?
For what it's worth I have been running my Pertronix Ignitor II system with an old Delco 32A generator for almost two decades. I will say that I...
All of the above are good recommendations. The only thing I'll add is if the easy checks don't solve your problem then disassemble the entire...
I smoked a Pertronix Ignitor I module by leaving the key on while troubleshooting a carb issue long ago. Switched over to the Pertronix Ignitor...
Happy birthday and enjoy your new toy. Looks great.
Gawd that is nice!!! Congrats to you and have fun.
Wait! So most of the trans fluid got sucked into the engine and burned off???
Got the balancer back from Damper Dudes. They did a super job. I sent them the balancer minus the timing ring because it looked damaged to me....
Yep Paul you were close it is a minimum ~2.2" to remove from the crankshaft...and it was a light press fit. Easy off with the puller. Lifted the...
Yes it looks like that thick section is cast into the unit. I'm just going to check the balance before and after to see if there is any change....
Separate names with a comma.
The Jalopy Journal