The Jalopy Journal
Here are some links to images and a few show the floor construction. I used some leftover exhaust pipe from my long gone truck for the tunnel,...
Link: http://www.directimagehost.com/pf.php?fid=8256 rerstoration project I did, a daily driver the owner wanted a tilt because engine access is...
Excellent! I also don't want to look for bling stuff, get it functional first. Fuel tank? Mine's under the floor on the pass side. Had mine out...
Daddy's girl helps as it's "her car" and her buddy also tags along.
37-42 springs are the same as the T, I think 39" centers static and 41" stretched to install. I started with the stock 37 spring but needed torque...
Yes, hold up OK. As a rule the pickups were 4.11 and the cars 3.78, optional was 4.56 in pickup.
fFrst thing, someone once indicated that the merc bellhousing is smaller and cause some interfearence issues with truck flywheel/clutch combos. If...
"good runner with low miles" translates to "why screw with it ?". Yes, the pumps will start to leak sooner or later. You could purchase the...
My understanding is there is interfearence with the wheel cylinder and some high spots inside '36 hubs. But others have said that it is small...
I have done it all ways, some pry down with the KRWilson tool, some the bottom of the guide snaps off. Sometimes cut the valves, cut the springs,...
Made one like that, central Texas to NY, BSA on a early Chevy Luv, no problems. Ratchet straps weren't invented then, small chains went from...
No, not yet at least. That's why I scoff every one I can on the chance It may be useable. And why the NOS one or 2 that turn up occasionally go...
I did one so far and like said, slow and check. I had my rails trying to curl in at the bottom on 2 different occasions. Easy to cut the tacks...
I used all 37 running gear and axles steering. 49 pickup pedals 46 car X member Link to chassis:...
Separate names with a comma.
The Jalopy Journal