The Jalopy Journal
That might be it. I believe mine has a groove around the end of it. Thanks.
I miss read it. I will look for the clevis pin. Thanks
Thanks for responding. It’s the actual rod/bolt that passes through and I believe had a spring on the end and held in place with the Clevis pin
Hello everyone. I am trying to find a part but cannot locate an actual part number or identification of it. After scouring the internet, I...
Here is what came back
The package I mailed to you just returned as “non deliverable”. Is there another address?
I think you are correct. At least on my 56 The split is at the master cylinder under driver seat. When my master cylinder went out I had to...
Send me you address and I will mail it. It will take some work on the threads but if they sell the flare sets you should be able to make it work....
I looked extensively for the bolt. In the end, another member was able to provide me one they had sitting in a shelf. Very lucky to have found...
Thanks. I was trying to find the female thread count. Thought it was 20 but 24 is the standard? So hard with the thread being so messed up.
Ok. Question: If one is 24tpi and the other is 20tpi will they thread together? I have not had to do this before Thanks
I think that’s what I have to do. Need to buy a tap/die set. I may also need to look at the thread on the male end. It says 1/4” inverted...
I am working on it. Learning a ton every time I make a post
Looks like it. Tried to find the exact specs on it. Thank you
Separate names with a comma.
The Jalopy Journal