The Jalopy Journal
That's quite a compliment, thank you! We're just doing the best we can with the tools we have. I hate to use the phrase "cutting corners" as such,...
@squirrel Here's a couple pictures of what I'm working with. The frame has nuts welded inside the rails in the factory '32 locations, which is...
Just wondering what some opinions are on whether or not crush sleeves are necessary in my application. I have made some subrails for my roadster...
I've installed lots of lap belts in cars over the years. I typically use the giant washers and shouldered bolts that they come with and *knock on...
I just wanted to run this by everyone and see if I'm on the right track. I've set up lots of engine/teans combos in various applications, but this...
Thanks for all the replies! I've decided to go with a set of 2" ones, as those will do what I want them to do, and also help fill up the engine...
I have an Offy 4x2 intake for a 348 I'm working on, and I'm wondering if carb spacers would have the same benefit here as they would with a single...
Squirrel you are the man! I appreciate you taking the time. I actually got ahold of two different third members, one has a short yoke and the...
That's what I needed to know! Thanks Squirrel! You are correct, the important measurement is axle center to U joint center. I already know the...
I'm sure ethis info is out there, but inswear search engines are getting harder and harder to get good answers out of them... Anyways, I'm...
I wasn't aware of Pete Aardema, but I looked him up and WOW that is some crazy stuff!!! Thanks for putting that on my radar, I love reading about...
Separate names with a comma.
The Jalopy Journal