The Jalopy Journal
[ATTACH]
Thanks, hadn’t decided if I should put inner door handles or just reach my hand out. I’d have to figure out some pulley system for the inside
I ended up just using the speedway bear jaw latches. Then I think it’s like Carolina customs makes the spring loaded mechanism for the shaft....
Got my outside door handles in with a little work https://youtube.com/shorts/uPtd0g-WLDs?si=_wXdhA-DbxYvibHz[ATTACH]
It honestly wouldn’t be too bad, my best friend is a firefighter in Bryan. I may have to take you up on that. CS is about a hour away
That’ll work for me. All the wood has been replaced on mine, but you can see where the tack strip would be. May be easier to just screw it into...
Jay- question for ya. I remember you blowing your car apart and it had the garnish molding. Did it all screw directly to wood? Or was it wood and...
Wouldn’t just fish plating pieces you but welded together do the same thing?
You’re probably right. I’ve seen more sets without the lock; I thought maybe the lock was an upgrade. Hell if that’s the case I have 4 right...
It makes sense but I’ve never seen it done. It looks good though
Freakin door fitment is night and day now [ATTACH]
I was thinking the same with mine. It's kind of a pain in the ass to try and run a outside handle with my latches.
Hahaha I have the original 35 Chevy inner and outter handles [ATTACH]
What’s everyone running for door handles? I have a set of originals but kind of a pain with these bear jaw latches.. I thought about running some...
I’m running a steel crank in my motor. With how light these cars are it’s still going to be a rocket. I got around to painting the doors put some...
Separate names with a comma.