The Jalopy Journal
The easy way to weld tube but joints is with a welding positioner (sp)...think grounded turntable. Based on the pic, it looks like the distance...
Wilwood makes a reverse M/C hanging pedal assembly, with either one M/C or two with a balance bar. Everything mounts to the firewall, and the...
I would suggest getting as many profiles as you can afford. The basic six piece set will get you started and do a lot of work, but the other...
Hossier Profiles can probably help you out with parts. http://hoosierprofiles.com/Home_Page.html These guys made a killer set of lower anvils...
Repair job I did last week. Prep is as important as the act of welding itself. Nice bright clean metal is required for a good sound weld,...
very cool!
If you're not exactly sure what torch you need, go to a local shop. It may cost you a few bucks more, but getting the right torch the first time...
As far as I'm concerned I'd cut it all off and start from scratch. You could try and TIG over all of the bad welds, but unless you put a huge...
A lot of the work that comes through my shop is repair work as a result of other shops. A good weld can be done with MIG, but its easy to make...
The diesel oils are not bad, but they are not designed for gas engines. While they have a lot of zinc, that zinc tends to flash off at a different...
Motul has a few formulations which are designed specifically for flat tappet engines. They contain high levels of zinc. They even have a specific...
Motul has some great oils designed for older engines....both synthetic, conventional, or a blend. What type does the engine builder recommend?...
Hello all! As a weldor and the owner of a small (just me) automotive/motorcycle/whatever-comes-through-the-door fab shop...I can say being...
Thanks a lot!
I'll be there with my wife and son....will bring along the wagon as well.
Separate names with a comma.