The Jalopy Journal
My build was with many parts from many cars. I would like to think it will be around longer than I am. I want to place in the car, under the...
That modification is similar to how a mechanical speedo is added to a T-56. it will work fine... but if you need the mechanical speedo drive gear...
looks like you are onto something good. Consider the vertical pleats with buttons like Henry did on the model T. Mat
I'm in LaGrange Ill. I used marine vinyl and although I know you can do it, I would definitely go through a few trials with less expensive...
[IMG]You could try doing some diamond tufting like this. If I can do it , so can you. No sewing involved. I used marine vinyl to withstand the sun...
It is not impossible, or that difficult, But you are correct in asking because you need the correct documents. and a little patience. I found the...
chevy universal throttle rod D&R classics part number M00124-U comes with one of these on the end. $11.95 yes, having the lathe is nice. Mat
I have used them for several years. They are not bad. The numbers will wear off after a while, especially on the most used sizes. They do stick...
It is not too hard but it can be frustrating. I'm just finishing on getting a constructed vehicle title. The SOS will sent an information...
I cannot give Tom enough thanks. His car is fantastic AND he donated his time at the show to the Ronald McDonald Charity, pin striping my...
I've used a dremel tool with a small grinding wheel. working it around the entire inside diameter. It will loose a little in concentricity but...
Yes! X2
Could never afford my dream car, so I'm building as close a replica as I could, buying and making the parts. 4 years after I started it is...
Another trick used to set small check valves in miniature steam engines is to place a small ball bearing into the seat and, using a drift and...
Separate names with a comma.
The Jalopy Journal