The Jalopy Journal
haha, Time for this gem again! [ATTACH] Any good oil around 30 weight will be fine man. Dont over complicate it. There is a split between...
First one was rough, but she turned out nice. [ATTACH] [ATTACH]
Bent spokes should be aftermarket like "Kelsey Hayes" they were stronger than the stock 1935 Ford straight spokes. Problem solved, put bent...
So I had a tudor sedan door from a 40 for the top metal. Took it and had to cut alot and figure out shaping, they are different for sure but...
Well, the problem persisted a while on this. After doing just about everything now. I may have found a culprit....
Man, I get it paying for the fun with em. Good looking car for sure! Thanks LT, yeah I this is a bit more than I really wanted to take on rust...
Well, I needed a break from structural so I decided to cut out the other bad part on the floor. Welded in some new 18 gauge. I didn't want to buy...
Thanks guys, I am looking forward to seeing what this turns out like. I decided last night to start on this area for the B pillar and floor tie...
Man that thing still has some workability to it.
Here we go!!!! The Why Not Project 36
Well, I have moved alot of iron over the last year, some long term attachments, some short term, but I have had an itch for a full build. Knowing...
Well, its getting to HOT season here, where I don't drive em as much, 95 with 95% humidity is not fun. But I have been chasing an issue once I...
I second this method. These fans pull a ton of air. And agree with above suggestions of a shroud.
In the event of power valve failure, they will start and flood the engine quickly. 2 questions, does it start, and can you keep it running by...
Separate names with a comma.
The Jalopy Journal