The Jalopy Journal
Right -- I'll be installing a used stock 302 cam with stock timing gears to calm down the beast so my sister can drive the thing. so I won't...
Thanks -- I thought that might be the case but wanted to make sure I didn't have to pull the whole front support or something. I'll be dragging...
Can you swap the cam in a small block powered early Falcon without pulling the engine ? I'm in Colorado, my sister just bought a 61 Ranchero...
Thanks everybody -- I was just concerned it was too easy to bend and therefore might be too easy to split under pressure. I've always heard...
Doing brake lines and a transmission vacuum modulator line too -- when I asked for 40 inches of steel line to do the vacuum modulator they said...
Yes -- That helps -- Thanks !
When I hook the spring up to the obvious location it pulls the vent open -- not closed. up inside the cowl vent all the way at the top there is a...
I ended up mounting the latch a little bit higher in the door -- there was enough wiggle in the shaft of the door handle to go up just a little...
My 37 coupe came without a door lock cylinder - so I don't have an old one to reference. The reproduction one I ordered has the square shaft...
If the Hi-Po exhaust manifolds are better than "most 302" manifolds then they are probably better than the 72 302 2 barrel exhaust manifolds I...
The amount of room available would dictate making headers that almost look like the same shape as stock manifolds, like one long runner from the...
Separate names with a comma.
The Jalopy Journal