The Jalopy Journal
yes 54 chevy 1/2 ton manual floor four speed
I "think" I understand the pre-load on the ball now after reading a little. I am still having issues figuring out where all the gaskets go. the...
hi 3/8" SAE bolt and lock washer...check adjusting the pre-load on the ball???????
photos as requested.
Hi, I am working on a 54 chevy truck 235 6 cyl 4 speed. I am connecting the torque tube drive shaft to the rear of the transmission. I have the...
I'm doing an engine hoist thru the cab lowering to get the trans in place.lots of cussing and a hole in the garage wall, but no install yet....
I can do this but had the trans mounted already so was trying to not remove it
I fully understand what your saying and I went out and stared and measured for a while and it seems to me even with the front axle off, the...
can you install a floor mounted four speed transmission attached to a 235 six cylinder in a 54 Chevy truck completely assembled? So motor bell...
Thanx everyone. I'm firing up the welder. Case closed.
Stock leaf springs
Separate names with a comma.
The Jalopy Journal