The Jalopy Journal
My '48 is stock right now and 9" at it's lowest point ... sad ... :) Fatman Fab sells a 3" dropped upright kit for 39-56 Chry Corp mosheens,...
My gut tells me these engines would respond better to a blower than a turbo, being all torque and low revving ... I'd be VERY interested in...
Thanks. We're setup to do the milling, just need the tooling guide. Two people I know claim ownership but neither can find theirs. :) -Sven
Not sure if this is the right term used for what I'm looking for. We have a pair of unmilled Baron flathead heads and we need to mill the...
I found the manufacturer/builder: http://www.nvbackflow.com/engines/ Damn! -Sven
http://www.gulp.org/videos/miniaturev8.mpg Wait until the fellas hand enters the pic to goose the motor ... [img] Have to respect someone who...
Thanks for the info, that's great stuff. No worries about the solder letting go before your motor does:...
Can anyone recommend a suitable 1.5" rigid but bendable tube material to be used for hard coolant lines and where to get it? I was thinking about...
Same here, Miller 175 on an extension cord I made myself from HD parts. I didn't, however, go the ghetto route of plugging it into the dryer, I...
Who cares, it's your car build what you like and fuck what other people think. -Sven
The 4AGE (any of them) will hook up to any Toyota T50 transmission commonly available in any of the RWD Corollas. The best to get tho', is the...
Get's my vote, FWIW ... I read 'em a few times but I'm reading them again just cause you took the trouble to post the links! -Sven
Separate names with a comma.
The Jalopy Journal