The Jalopy Journal
So no one on here ever piled in a death trap and went as fast as it would go ! and never gave it a second thought.
I have not found a lot of info on Truck arm installation methods. I do have some friends I will call on as I get ready to build the crossmember. I...
I spent some time cleaning up the shop and pulled another string down the right side. All is good, both sides are within a heavy 16th of an inch...
Weldcraft wheels in Livonia Mi.
I would say they are cold.
That's one word for it !
Why not ?
We are using the rails we have , so I am working on that. The string is within a heavy 1/16 th from one end to the other. So this looks to be a...
With the motor warmed up and idling just cup your hands over the carb, if it picks up RPM it has a leak, if it chokes down no leak. Or use a rag !
You also said it is popping out the exhaust, as a general rule back firing out the exhaust is usually ignition related and looking back through...
If the choke is set to tight it will want to close when you open the throttle and the pull off won't overcome the spring pressure of the choke....
These are interesting symptoms, poor cold performance , running bad , mis-firing , bad drivability then it clears up when hot. This sounds like...
That would be correct, but it needs to be centered to the output shaft of the trans. That is what we are after here. On the cheap, without cutting...
I have access to more housings both Cup Car full floaters and stockers. The budget plan is to find one to fit as is. Time will tell what I find....
This is the most likely problem, the o-ring jar racer referred to is on the tube where it goes up in the case. The best filter to put in it is a...
Separate names with a comma.
The Jalopy Journal