The Jalopy Journal
Considering that these once ubiquitous engines are now anything but, I would look for a flathead expert/specialist who has the tribal knowledge...
Warning! You can't unsee it. [IMG]
Wescott was wrapping up their operation a couple months ago. I don't know if anything is still available.
Well, If they moved to California in '53 and Bob died in 2009, the club you're looking for is probably in the bay area.
I agree that the chance of three consecutive runs being exactly equal is about zero. The plot thickens.
Are you swapping it because of the high idle?
I have to agree that there is a problem here that should be corrected before power steering is added to the equation. After all the geometry and...
tt
You may or may not; hard to predict. It's cheap and easy to install during a build and will be there if you need it.
Every opinion on this subject is biased.
Not really practical. Electric resistance heaters use a lot of power, probably more than your truck's electrical system can generate. The standard...
Roll the car over and pour it in the drain hole.
Looks like the discs bolt to the back of the hubs, not to wheel/stud face. Wheel to kingpin spacing appears to be in the same ballpark as most others.
Almost as scary as the pics of my chop (the avatar '33). The difference is you knew what you were doing; I had to make it up as I went along.
Before modern electronics made VFDs practical and popular, a rotary phase converter was typically used when 3 phase was needed in a location where...
Separate names with a comma.
The Jalopy Journal