The Jalopy Journal
[ATTACH] The 660 Holley 4224 center squirter tunnel carburetors came from the factory with the metering blocks blank where the power valves would...
I have never totally solved bog problems on a tunnel ram while the power valves were still in the carbs, that's just my experience, came close...
Bought some stuff from the hamb classifieds with success, first PM them and let them know I'm interested, then ask for their phone number. After a...
Loved my old, lowered s-10 daily driver it was 2.8 5 speed = 24 mpg, the Wisconsin winters rusted it until the box was going to fall of :oops:...
The truck motor will handle it, giddy up giddy up 409 :D
Beautiful truck, Awesome Job :cool:
Speedway Motors Part number 2897740R for 239-255 Flatheads, got mechanical and vacuum advance :)
[ATTACH]
My attempt to make Vortec heads look 64 correct, drilled the Vortec intake for the oil fill breather tube, also have valve cover adapters under...
Finally got some of the chrome bolted on this old fiberglass front clip, now got to move the front clip mounts for the grill to clear the frame...
[ATTACH]434 waiting for its new home in a 56 Chevy gasser, 327 valve covers because they are my favorite sbc covers
A 1967 2 door post drag car cut up and has an aluminum floor and trunk, weighed 3040 with me in it. A single 4 ram is a bitch to keep in tune...
Drag raced a 327 with a set of 492 angle plug heads in a 3040 lb. 5.38 gear O.T. Chevelle, it had a best E.T. of 11.97 but I think it would have...
1/4-mile ET with 336 hp in a 2700 lb. car should get you well into the 12s
Do you have a copy of the runs on a dyno sheet and what was the air fuel ratio with the 750, it may be a tuning problem, I feel your healthy 327...
Separate names with a comma.