The Jalopy Journal
Looks like you could use some of our products too.
Gear ratios and fuel mileage will depend a lot on how the engine is built and your driving habits. The 3.0 is probably the best one for your...
It was told to me by a PPG rep probably 50 years ago to put the epoxy down first, then filler, then epoxy prime. This puts the filler in a...
Tim, I have used the PPG Shopline epoxy primer quite a lot and have been quite satisfied with it. I also like Eastwood's 4:1 high build primer...
They look like 37 Chevrolet
The Enos panels are still available through www.racersrods.com
Gary, for kits I personally use AAW almost exclusively, mainly the Hiway series. For wiring supplies, try Waytek also, they seem to be less...
As always Tom, your photography is un matched, thank you!
[ATTACH]
Yes, on our website. Go to the Product Catalog, then to the suspension dropdown, then to the shock kits dropdown. It is pictured in the shock kit...
Does Alan Grove make a mount that places the alternator over the valve cover or just the one that puts it above the intake manifold?
Check with Wilwood, their single puck caliper is pretty much the same as the Airheart.
Block hugger headers don't work well on 40's. We used to make an exhaust system for 35-40 Fords with SBC and we did have one for the block...
Looks similar to 50's era Willys two wheel drive. The Willys only had one leaf spring though.
BJR is correct, the ONLY thing we take deposits for is frames/chassis, otherwise, we do not charge a card until the product is in the box ready to...
Separate names with a comma.
The Jalopy Journal