The Jalopy Journal
Arrived in sw Ks. today.
I've built and sold 3 of them. Now that I'm old, I like the large back window of the last version more. LOL.
Impact wrench without a doubt. If it was loctited, you will have a terrible time with a breakover. I have been down that road before on a newer...
Brookville makes them for their version of the cab.
Yes but not well. Most pumps make pressure but have limited suction. The farther away from the tank the worse this gets. Depending on what has...
No resolutions here. it's been 2 years since I completed my last project which is my daily driver. I keep an eye open all of the time looking but...
A few years ago, the State farm agent offered me a Hagerty.I explained to her that you can't daily drive on their policy. End of discussion. :)
In the past, I was one of the 1st to get mine. Not so this time. :)
Put bend of around 30 to 45 degrees in the system and the drone will be gone. I had late model mustang gt mufflers before the axle on my 32. I...
They are pent roof like most 4 valve heads.
If you were close to me, I would have you bring the rod and piston assemblies over and I would clamp them in a fixture and cut the domes...
Does the exhaust sound right or flat? Sometimes retarded ignition will make an engine sound "sick". I doubt that is your problem. If you knew...
Before you get too far along, how about a compression test to see what the general condition of the engine is? There maybe be more to the story....
I have used all but AMD. I have had good results with all. There have been problems but always resolved to the proper solution. I have used LMC a...
What are you going to use for an ecu?
Separate names with a comma.
The Jalopy Journal