The Jalopy Journal
Yeah, instead of "valve clearance" I suppose I should say "valve relief"
Check this out: https://www.jalopyjournal.com/forum/threads/eddie-meyer-heads.952069/
I'm still very much a newb, but perhaps the 500 is referencing valve clearance? I know my Offenhauser heads are stamped "400" on the top edge,...
Thanks, guys this is all very helpful.
...also "Gusseted and reinforced for some reason" made me laugh, I can relate.
Likely a little more than I am wanting to spend. Looks great! Sending you a PM...
Nice, thanks -- I like the look of that cover.
Thanks for the offer, very cool -- but those mount points are the stock coil mount location, right?
@19Fordy -- Thanks, I'm going to give that a shot -- I appreciate you sharing the dimensioned drawings too, very cool. @GordonC -- No concerns...
Suppose I should mention the engine is in a 32 roadster (open, no hood) that is driven often, not a show car, and trying to maintain a traditional...
Hi all, I'm installing some Offy heads I picked up at Pomona a while back on an 8BA and the threaded holes where the coil bracket is attached have...
My understanding is that "normal" adjustable-style versions work, but not as well as a solid tapered one.
Thanks, guys. I've thought about asking my dad to make me one on his lathe, I might go that route. Gives him another project to do in his...
Apologies for bumping a 10-year old thread, but I'm in the market for a solid tapered ring compressor for a 3.3125" bore too. ARP has an 84.0mm...
Separate names with a comma.
The Jalopy Journal