Ziggster's Recent Activity

Ziggster attached a file to the thread Projects My GN Cycle Car tribute build.

Likely the first attempt before building the flex tubes and collector. Looks naked. Haha! [ATTACH]

Ziggster attached a file to the thread Projects My GN Cycle Car tribute build.

And Petro Shekhter’s creation which is what I will shoot for (single seat vs the dual seat design of Richard’s). My collector tube is...

Ziggster attached a file to the thread Projects My GN Cycle Car tribute build.

A pic as a reminder of his GN JAP creation. [ATTACH]

Ziggster attached a file to the thread Projects My GN Cycle Car tribute build.

Had to just mock it up. Third coat was uneven as it’s really hard to see under my deck. Third flex tube is too short. Also missing a...

Ziggster liked K13's post in the thread Technical Question for the Pros - Sanding for Paint Prep - High Spots.

To get something flat you need to sand it as a whole not just here and there where you add filler. You will chase your tail forever...

Ziggster attached a file to the thread Technical Question for the Pros - Sanding for Paint Prep - High Spots.

Haha! We’ll see. There is about an 18” flex tube between the manifold on the engine and the inlet to the collector. I think the max temp...

Ziggster attached a file to the thread Technical Question for the Pros - Sanding for Paint Prep - High Spots.

In my case, I would tend to agree with @anthony myrick In terms of over sanding and not applying enough filler generally speaking. The...

Ziggster attached a file to the thread Technical Narrowed and Shortened Radiator for Flathead.

I’m using a rear mounted rad in my speedster build from a Dodge Dakota. Probably is slightly too big for what you need, but it is way...

Ziggster replied to the thread Technical Question for the Pros - Sanding for Paint Prep - High Spots.

High spots for sure. Gobs of hi-temp epoxy stuck to the surface of 4” round exhaust collector tube, but it doesn’t matter. Gage the sane...

Ziggster attached a file to the thread Projects My GN Cycle Car tribute build.

Just finished sanding the collector again. Will paint after lunch. Much cooler out. Was only 48F this morning. High will only be 66F....

Ziggster replied to the thread Technical Question for the Pros - Sanding for Paint Prep - High Spots.

Using my thumb/hand. Come to think of it, I rarely use a block or anything like that. Did a patch panel repair on one of my OT vehicle...

Ziggster posted a new thread.

Technical Question for the Pros - Sanding for Paint Prep - High Spots

A question I’ve been meaning to ask for a long time is why is it every time I’m sanding down high spots is that the first thing to...

Forum: The Hokey Ass Message Board

Ziggster liked Rickybop's post in the thread Folks Of Interest Matt from Strong's Garage in bad accident..

Jesus Lord in heaven... Please help Matt.

Ziggster liked 05snopro440's post in the thread Folks Of Interest Matt from Strong's Garage in bad accident..

Update shared on the Go Fund Me yesterday:

Ziggster liked 05snopro440's post in the thread Folks Of Interest Matt from Strong's Garage in bad accident..

The Go Fund Me was paused yesterday as they raised more than enough money to sustain them for a long time.