Register now to get rid of these ads!

1952-59 Ford my project '57 Ford 2 dr Custom

Discussion in 'Off Topic Hot Rods & Customs' started by Texas57, Feb 26, 2014.

  1. Texas57
    Joined: Oct 21, 2012
    Posts: 3,742

    Texas57
    Member

    OK..after the warm welcome, I decided to risk the OT police and post some pics. I started this about 7 years ago, been finally making some progress in the last year. Being retired helps alot for the time aspect, not so much for the funds available. Major things done so far: about 3 1'2 years spent rebuilding the body. floor pans, rebuilt trunk, inner and outer rockers, inner and outer rear quarters, rebuilt front fenders, all 4 wheel wells. Body off and 100% strip to bare metal. Hand formed the rear roll pan,eliminated almost all body seams.Paint is basecoat/clearcoat, all stainless has been restored, all rubber replaced, all new gl***, almost every nut and bolt replaced with stainless(non structural) tailights are 63 Galaxie 500 xl with added outer ring, hood has '83 Mustang GT scoop, all handles new, all door latches NOS, cowl area smoothed,
    Interior: front and back seats from Mitsubishi eclipse '93(?)refinished and redyed, reformed the dash, fabricated center console, '97 Mustang steering column (fully functional including variable speed wipers) Gen iv a/c, pwr. windows, new carpet, headliner. New door panels/rear side panels, rear seats fold down,billet a/c vents and controls,shifter is '95 Lincoln Mark viii
    Mechanicals: granada discs/dropped spindles, HD sway bar, rebuilt suspension all new components including springs and control arm shafts, R & P steering, 4.6 efi dohc from a 1 owner 52k '95 Lincoln Mark viii, 4r70w ******(electronic OD), Mark viii shifter, mark viii alum. driveshaft, fan and shroud '95 Mark viii,oem style aluminum radiator, K&N filter, Ron Francis express wiring harness, '97 Mustang variable speed wiper motor accesible from under dash,hard arm wiper system to replace pulley and cables

    I just got the engine put in a few months ago, am working on the plumbing, then on to finishing the chasis wiring and then the engine management harness/ computer.
     
  2. JeffB2
    Joined: Dec 18, 2006
    Posts: 9,665

    JeffB2
    Member
    from Phoenix,AZ

    If you put the Pix here in the Group it is OK,we can all learn and share from that, if you keep it off of the HAMB main board you should be safe from the watchdogs.
     
  3. 57 Ford Kustom
    Joined: Jan 28, 2014
    Posts: 23

    57 Ford Kustom
    Member

    Rich, Thanks for sharing!
    Tim
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.