1932 Ford fibergl*** by Brinkley Enterprises using the front half of the Harwood mold and using the back half of the Zipper mold. It was ***embled on the existing frame. Tub is powered by a late 350 carbrated roller motor, 700R4 trans and a 9" Ford rear-end. 5" drilled axle and Wilson Welding backing plates and Buick drums. Rear-end is supported with coil over shocks. Wheels are Cad wires with BFG big and little wide whites. Seats are set low and back for comfort on long trips. Car runs and drives very well. I would also consider selling body minus windshield , posts, gauges and steering column/ wheel for $12,500. Bob 503-970-9587
The Jalopy Journal
