Customs Please recomend a curved glass cutter in/near Wisconsin

Might anyone be able to recommend a curved gl*** cutter / installer in Wisconsin, Illinois or Iowa? My '51 Chevy was chopped a long time ago and the de-laminating windshield needs to be replaced.
Thanks

 

I'll put it up for the evening crew.

 

I took my car to PS auto gl*** in Janesville. I think they also have a place in Madison. It wasn't cheap but I was very pleased with the results

 

If you have no luck with gl***, try ProGl*** in Yorkville, Il. Bob does great work in composite materials.

 

Maybe check out the Gl*** Guy Chicago. https://www.facebook.com/Gl***GuyChicago

 

you can use a sandblaster to cut gl***... tape off the gl*** you want to keep.. use thick duct tape.. and blast along your cut line... when it gets to the plastic.. cut that with a razor.. flip over and repeat..
support it on foam, or tires, or sawhorse..
I hold a piece of tin along the line to make sure the sand doesn't cut thru the tape.... when you are done, the gl*** will have a polished edge
hope that helps

 

Nice car. Good luck and let us know the outcome and the process used. This topic is common and it's nice to know what good steps were used.

 

I have been using Gl***works from Edgerton, WI for quite a few years. I am very satisfied

 

Thank you all for your advice.

 

remember when you use sand to cut gl*** it generates lots of heat and that will break it, have a air supply blowing on area to be cut increases your success rate. it takes lots of patience!

 

j and f gl*** in racine does a lot of hot rods. he is across the street from the police station. i have been happy with his work and have known him for over 30 years. 262-634-1341

 

I've heard a water jet works great.