Hot Rods THE INDUCTION THREAD

Here's my Man-A-Fre for a small Ford (289) that uses 4 Rochester 2-jets. WAY better than the 2 Edelbrock 500's I had before, good down low and pulls to 8,000 rpm.

100 2754 2 by Kamp posted May 26, 2011 at 4:19 PM

 

That is neat I can't remember ever seeing a Man-A-Fre on a small block Ford or any other ford powerplant.

 

Kamp - The 289 is a crankin' little engine. Always liked the little Ford.

 

Yeah, thanks, I like the 289. Runs 12 teens at 110 mph...not too bad for a 9.25 compression pump gas street car under 300 cu.in...

 

Here's a few from my collection

 

this is essentially correct.

 

I think my Crower will take that top...but I will just have to leave as is... just a fresh up and a tune up.

 

posted by hotrodderhaag in his thread
http://www.jalopyjournal.com/forum/threads/the-ben-haag-394-b-32-ford-3w.1009026/page-6

 

Found on the net trying to figure out what carbs those are?

 

Interesting, I can not tell what the hell they are! Maybe someone will know.

 

Hard to tell, but I think they are 4V Strombergs.

Sent from my XT1585 using The H.A.M.B. mobile app

 

Lutz & Lunderberg

what's up with the headers at the flanges

 

posted by swi66 in the vintage thread. Get a load of the air catcher

 

WOW! No lack of air being feed to that 4 port.

 

That's as big as Art Malone's mail box scoop!

 

The one I did when I was short for entertainment

 

Heres mine....

 

Looks like you had way more work than mine and it shows.

 

wow that Lincoln tri power setup is baddd

 

OK Mikey and other experts what is this SHORT injection unit and scoop? (car in near lane)

 

Not a lot of detail showing in that photo but both Hilborn and later Crower built injectors like that, as did Enderle with the throttle shaft and*****erflies on the front of the scoop, I'm not sure which one that is. Hilborn and the Crower are four hole, and the more popular, taller Enderle is three hole. Enderle's are in three sizes, the early Bug Catcher, then the Bird, and lastly Buzzard.

 

.....

 

1939 FLATHEAD

 

I would have to guess, CROWER, but hard to tell exactly from the picture. Cool shot for sure.