Hot Rods 54 239

Picked up this fresh rebuild last week....I am stoked!!! Going in my 54 customline!

 

Good looking motor, but it appears to be a truck engine. Hope you have your original car engine. You will need to swap bellhousing, thermostat hsg, water pump and fan, and oil pan, and discard the front mount in lieu of the car side mounts. Clutch disc is probably wrong also. Dipstick may need attention also, which may require a change in timing cover. Can't remember for sure on that. Good luck and have fun.
Farmalldan

 

I will swap it out when I pull the engine out of the car and set side buy side...

 

I think the water pump is the same but will look closer when out..I think i need to change the harmonic balancer also

 

Great. That should work fine.

 

Picked one of these up for the new Y Block Yesterday!! This is getting fun!!

 

There is two different water pumps

 

Then if you are putting the fuel in it needs to get out! http://www.spotlitekustomaccessories.com/store/p8/Ford_Y_Block_Headers.html

 

Thanks Jeff! I have a set gonna uncap the Lake Pipes and let her rip...